Updating ku990 firmware Anonymous dirty sex chat free

In order to use SD card with Trek Buddy, you have to create folder structure by hand (of course you do not need to create folders Tracks and waypoints files created by user are stored in internal memory which is unfortunately not easily accessible, unless you have Windows 8 PC where you can use Windows Phone Power Tools.

Keep on top of your profession and utilise your unlocking equipment to it's full potential. The installer will search for connected Genie and will select the destination SD card on Genie.Date: November, 2007 / Issue 1 .0 o 0) C 0) LG Internal Use Only Service Manual U990/KU990 Table Of Contents 1. PERFORMANCE 3) Transmitter - HSDPA Mode No Item Specification 1 Maximum Output Power Sub-Test 1=1/15, 2=12/15 21~25d Bm/ 3.84 MHz 3=13/15 4=15/8 20~25d Bm / 3.84 MHz 5=1 5/7 6=1 5/0 1 9~25d Bm / 3.84 MHz 2 HS-DPCCH Sub-test in table C.10.1.4 Power step Start of Ack/Nack boundary Power step size, P [d B] Transmitter power step tolerance [d B] 5 1 Start of Ack/Nack 6 /- 2.3 2 Start of CQI 1 /- 0.6 3 Middle of CQI 0 /- 0.6 4 End of CQI 5 /- 2.3 3 Spectrum Emission Mask Sub-Test : 1=1/15, 2=12/15, 3=13/15, 4=15/8, 5=15/7, 6=15/0 Frequency offset from carrier Af Minimum requirement Measurement Bandwidth 2.5-3.5 MHz -35-15(Af-2.5)d Bc 30 k Hz 3.5-7.5 MHz -35-1(Af-3.5)d Bc 1 MHz 7.5-8.5 MHz -35-10(Af-7.5)d Bc 1 MHz 8.5-12.5 MHz -49d Bc 1 MHz 4 Adjacent Channel Leakage Power Ratio (ACLR) Sub-Test : 1=1/15, 2=12/15, 3=13/15, 4=15/8, 5=15/7, 6=15/0 43d B @ ±10 MHz 5 Error Vector Magnitude 3GPP Not Complete Copyright © 2007 LG Electronics. PERFORMANCE 4)Receiver - GSM Mode No Item GSM DCS & PCS 1 Sensitivity (TCH/FS Class II) -105d Bm -105d Bm 2 Co-Channel Rejection (TCH/FS Class II, RBER, TU high/FH) C/lc=7d B Storage -30 - 85 3 Adjacent Channel Rejection 200k Hz C/la1=-12d B C/la1=-12d B 400k Hz C/la2=-44d B C/la2=-44d B 4 Intermodulation Rejection Wanted Signal :-98d Bm 1st interferer:-44d Bm 2nd interferer:-45d Bm Wanted Signal :-96d Bm 1st interferer:-44d Bm 2nd interferer:-44d Bm 5 Blocking Response (TCH/FS Class II, RBER) Wanted Signal :-101d Bm Unwanted : Depend on Frequency Wanted Signal :-101d Bm Unwanted : Depend on Frequency LGE Internal Use Only - 14 - Copyright © 2007 LG Electronics. The quad-band GSM transmitters use a baseband-to-IF upconversion followed by an offset phase-locked loop that translates the GMSK-modulated or 8-PSK-modulated signal to RF. The UMTS and GSM Rx baseband outputs share the same inputs to the MSM IC.INTRODUCTION 5 1.1 Purpose 5 1 .2 Regulatory Information 5 2. PERFORMANCE 2) Transmitter - WCDMA Mode No Item Specification 1 Maximum Output Power Class 3 : 24d Bm( 1/-3d B) 2 Frequency Error ±0.1 ppm 3 Open Loop Power control in uplink ±9d [email protected], ±12d [email protected] 4 Inner Loop Power control in uplink Adjust output(TPC command) cmd 1d B 2d B 3d B 1 0.5/1.5 1/3 1.5/4.5 0 -0.5/ 0.5 -0.5/ 0.5 -0.5/ 0.5 -1 -0.5/-1.5 -1/-3 -1.5/-4.5 Group (10 equel command group) 1 8/ 12 16/ 24 5 Minimum Output Power -50d Bm(3.84MHz) 6 Out-of-synchronization handling of output power Qin/Qout : PCCH quality levels [email protected]/lor : -22 --18d B 7 Transmit OFF Power -56d Bm(3.84MHz) 8 Transmit ON/OFF Time Mask ? Only for training and service purposes - 11 - LGE Internal Use Only 2. For the transmit chains, the RTR6275 IC directly translates the Tx baseband signals (from the MSM device) to an RF signal using an internal LO generated by integrated on-chip PLL and VCO. PERFORMANCE 5) Receiver - WCDMA Mode No Item Specification 1 Reference Sensitivity Level -106.7 d Bm(3.84 MHz) 2 Maximum Input Level -25d Bm(3.84MHz) -44d Bm/3.84MHz(DPCH_Ec) [email protected] 20d Bm output power(Class3) 3 Adjacent Channel Selectivity (ACS) 33d B [email protected] 20d Bm output power(Class3) 4 In-band Blocking -56d Bm/[email protected] 1 0MHz [email protected] 20d Bm output power(Class3) -44d Bm/[email protected] 1 5MHz [email protected] 20d Bm output power(Class3) 5 Out-band Blocking -44d Bm/[email protected]=2050~20~2230MHz [email protected] 20d Bm output power(Class3) -30d Bm/[email protected]=2025~20~2255MHz [email protected] 20d Bm output power(Class3) -15d Bm/[email protected]=l~20-1 2500MHz [email protected] 20d Bm output power(Class3) 6 Spurious Response -44d Bm CW [email protected] 20d Bm output power(Class3) 7 Intermodulation Characteristic -46d Bm [email protected] 10MHz -46d Bm/[email protected] [email protected] 20d Bm output power(Class3) 8 Spurious Emissions -57d [email protected]=9KHz~1GHz, 100K BW -47d [email protected]=1 -12.5GHz, 1M BW -60d [email protected]=1920MHz~1 980MHz, 3.84M BW -60d [email protected]=2110MHz~21 70MHz, 3.84M BW Copyright © 2007 LG Electronics. PERFORMANCE 6) Receiver - HSDPA Mode No Item Specification 1 Maximum Input Level (BLERor R), 16QAM Only Sub-Test : 1=1/15, 2=12/15, 3=13/15, 4=15/8, 5=15/7, 6=15/0 BLER = 700kbps 2.4 Current Consumption 1) KU990/U990 Current Consumption Stand by Voice Call VT WCDMA Under 4.00 m A (DRX=1.28) Under 350 m A (Tx=10d Bm) Under 550m A (Tx=10d Bm) GSM Under 4.00 m A Paging=5 period Under 300 m A (Tx=29d Bm) (Stand by and Voice Call Test Condition : Bluetooth off, LCD backlight off, Neighbor Cell off) (VT Test Condition : Speaker off, LCD backlight On) LGE Internal Use Only - 16- Copyright © 2007 LG Electronics. Acoustic (Max Vol.) MS/Headset SLR :8±3d B MS/Headset RLR : -15 ±3d B/-12d B (SLR/RLR : Mid-value setting) MS and Headset Max Under -62 d Bm 2.8 Charging • Charging Method : CC & CV (Constant Current and Constant Voltage) • Maximum Charging Voltage : 4.2 V • Maximum Charging Current : 600 m A • Normal Battery Capacity : 1000 m Ah • Charging Time : Max 3 hours (except for trickle charging time) • Full charging indication current (charging icon stop current) : 80 m A • Cut-off voltage : 3.20 V (Stand-By), 3.10V (Talk) LGE Internal Use Only - 18- Copyright © 2007 LG Electronics. TECHNICAL BRIEF 3.1 General Description The U990 supports UMTS-2100, GSM-900, DCS-1800, and PCS-1900 based GSM/GPRS/EDGE/UMTS. The UMTS receive paths each include an LNA, an RF band-pass filter, and a downconverter that translate the signal directly from RF-to-baseband using radio One ZIF techniques. Only for training and service purposes - 15- LGE Internal Use Only 2. GSM : Power Level : 5 DCS/PCS : Power Level : 0 (Cell Power : -90 - -105 d Bm) -. Only for training and service purposes 3, TECHNICAL BRIEF 3. The antenna connects with receive and transmit paths through a FEM(Front End Module).

Search for updating ku990 firmware:

updating ku990 firmware-46

Data Card Smart Tool 1.6 Data Card Smart Tool 1.6 Added: - ZTE MF 100 direct unlock - ZTE MF 330 direct unlock - ZTE MF 332 direct unlock - ZTE MF 335 direct unlock - ZTE MF 616 direct unlock - ZTE MF 620 direct unlock - ZTE MF 622 direct unlock - ZTE MF 622 direct unlock - ZTE MF 626 direct unlock - ZTE MF 627 direct unlock - ZTE MF 627 direct unlock - ZTE MF 628 direct unlock - ZTE MF 630 direct unlock - ZTE MF 630 direct unlock - ZTE MF 633 direct unlock - ZTE MF 633 direct unlock - ZTE MF 633bp direct unlock - ZTE MF 635 direct unlock - ZTE MF 636 direct unlock - ZTE MF 637 direct unlock - ZTE MF 637U direct unlock SAG DD Sagem EG_V13.6 released! Kulankendi BOX: Multi-Language with language ini for Kulankendi exe released !!!

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “updating ku990 firmware”

  1. Our vast general knowledge makes us a bit cocky as well so make sure to have your facts straight before confronting a Croatian girl on a certain subject or you might get schooled.